How is PE protective film produced?

About PE protective film, the most reflected situation is the problem of protective film deglossing, this problem is most reflected in the profile protective film, when the profile installation construction is completed after the protective film from the profile surface tear down, the protective film on the adhesive is not with the protective film was torn down together, but residual in the profile products. So how do we solve this problem?

Customers are most unwilling to see is the protective film torn after the product is still left on the residual glue, because it is very troublesome, need to specialize in these glue from the profile scrape down, especially labor-intensive and time-consuming, there are a variety of possibilities for this kind of problem, the biggest possibility is that the manufacturers in the production of PE protective film with the pressure of adhesive does not comply with the provisions of the regulations, that is, it's too viscous, resulting in the protective film in the peel, the outer tension is greater than the internal stress, and remain on the profile. If this problem occurs, you can use a clean rag dipped in a little alcohol, the residual sensitized adhesive for repeated rubbing, until the sensitized adhesive is wiped clean, but need to pay attention to is in the conduct of the rubbing must not be too forceful, or it may affect the finish of the profile products. Of course, the most important thing is to choose the right PE protective film manufacturer!